4-07 Aux 2 Input – This option changes the input behavior of the instant trigger wire on the Aux Input
Sensor green connector.
Default 1:. Will instant trigger with a negative (-) ground input.
Option 2: Will pre-warn with a negative (-) ground input.
Option 3: Will arm the alarm with a negative (-) ground input. Used when adding an alarm to a
factory keyless entry system.
Option 4: Changes the output into an open circuit input.
4-08 Extended Accessory After Ignition Shutoff (Negative Output) – This option keeps the Accessory wire
powered up after the ignition is shut off. This can be used to keep the radio turned on even after the
key is removed from the ignition (similar to GM vehicles).
4-11 Bypass Brand Through RS232 Port – Default setting allows for compatibility with ADS Idatalink
modules. Setting 2 changes compatibility to Fortin bypass modules.
4-12 Impact Sensor - This option changes between the standard included shock sensor and the
optional DAS Sensor. The DAS sensor has additional programming. Please see the Placement and
Use of Components section of this manual for details.
4-13 Antenna Power Save - Some people may not drive their vehicle very often, this may cause the battery
to become discharged because it is not getting recharged on a regular basis. The antenna power
save option will turn off the antenna after the specified amount of time to conserve power. While the
antenna is asleep, the system will not respond to the remotes. Any type of input to the system will
wake up the antenna, i.e.: ignition, brake, door, trunk, hood, shock, rps, ect. This means that a
remote start only user just needs to open their door to reactivate the system, however, a user
with an alarm or alarm/start system will need to trigger the prewar stage of the shock
sensor to quietly wake up the antenna.
4-14 Low Battery Warning - This feature option which is default to off. When the system is armed and the
feature is on the main control unit will monitor the voltage of the vehicles battery at its connection
point. When the battery voltage drops to or below 11.3 volts the control module will send a page to
the 2way. It will beep several times for 5 seconds, every 50 seconds, 3 times and flash the battery
indicator on the remote. When you query the remote or unlock/disarm the system the remote will
display the voltage of the vehicle’s battery.
CM6300 Install Guide
Alarm System
www.firstechonline.com | www.compustar.com
Copyright 2011 Firstech, LLC.
Page 25
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels